Home > Company News

Company News

12/07/2016
Corn stalk wood pellet machine is the straw pressed into granular machinery and equipment. Straw particle machine is based on crop straw as raw material, through the granule machine to suppress the cylindrical particles, straw particles in addition to bio
11/29/2016
wood pellet machine is necessary to carry out reasonable maintenance idle, ring mold as a major component of biomass pellet machine, the preservation conditions is also very important, then how to save it?
   Biomass pellet machine ring mold which condit
11/22/2016
Adjustment of mold roll gap
         (1) and the outer surface area of the pressure roller (2), loosen the retreat nut (6), and then remove the mold cover, (2) adjust the direction of the arrow wheel to adjust the gap, the gap becomes smaller, in the opp
11/15/2016
Biomass wood pellet machine, if used improperly, will produce the output is lower than the standard expected production of the situation, the use of a long time there will be a decline in production problems. As a professional manufacturer of biomass pell
11/08/2016
There are many raw materials for fuel pellets, such as wood, grain, alfalfa, corn husks and straw, grass clippings, garden wastes, forest and agricultural waste. In this article, we will focus on the introduction of particles made of wood, but with other
10/25/2016
Roller: Adopt the latest German technology one-piece packaging, whole life cycle, no need adding grease and no need replace the bearing.
2.Bearing for main shaft: using the gearbox oil to do lubricating, lubricated the bearing, and also cooling the main
10/18/2016
Drum dryer is widely used in food, feed, chemical, pharmaceutical, mining and other industries. The working process of the equipment is as follows: after the dehydrated wet material is added into the dryer, the material is uniformly distributed in the dry
10/11/2016
pellet mill makes abnormal noise due to the following reasons
  1.The raw material feeding speed is not stable, and shall be adjusted.
2.The deflective blades are wearing out which results in uneven feeding. Blades shall be replaced.
3.It is suggeste
10/03/2016
Particle machine spindle bearings and roller bearings automatic lubrication technology is due to the granulator spindle bearings and roller bearings work in high temperature, high humidity and high dust harsh environment, the need for good lubrication of
09/12/2016
One, strict control of the nature of the feed
Control feeding properties mainly include three aspects:
An excellent material is prohibited to enter, at the same time in the production process to non crushing material into the granulation chamber.
Two i
TOP